Southmountain
Member
- Joined
- Mar 17, 2022
- Messages
- 71
Please move if this is in the incorrect forum. I'm looking to get a rear peep sight for a Winchester M70 (pre-64). Anyone used a Lyman 57 WJS sight on these? With the front factory sights, it seems like the rear sights need to be pretty low and I'm worried that at the lowest height/elevation setting, the elevation screw will cut into the stock.
Are the new aluminum 57 WJS sights (link) also like this picture below of a vintage steel 57 WJS, where the elevation screw protrudes below the block at the lowest height? If so, does this present a problem with Winchester M70's?
Thanks in advance for any insight. I've asked this question in some other forums but haven't gotten clarity
Are the new aluminum 57 WJS sights (link) also like this picture below of a vintage steel 57 WJS, where the elevation screw protrudes below the block at the lowest height? If so, does this present a problem with Winchester M70's?
Thanks in advance for any insight. I've asked this question in some other forums but haven't gotten clarity