Hello Folks,
I have a new M&P 40 Pro that is having failure to feed issues.
Round is getting stuck on the feed ramp. Not a mag problem - happens with several.
It is worse with lighter loads which I can understand with everything being tight and stiff recoil spring in a new pistol.
But, I have seen a couple posts for the same issue where it was suggested that shorter COL may be the issue.
What COL are people using for the M&P 40 Pro. I have been using 1.125 (getting 1.122 to 1.128 variance).
Should I push it out to 1.135 or even a little longer 1.140?
Suggestions are much appreciated.
Thanks,
I have a new M&P 40 Pro that is having failure to feed issues.
Round is getting stuck on the feed ramp. Not a mag problem - happens with several.
It is worse with lighter loads which I can understand with everything being tight and stiff recoil spring in a new pistol.
But, I have seen a couple posts for the same issue where it was suggested that shorter COL may be the issue.
What COL are people using for the M&P 40 Pro. I have been using 1.125 (getting 1.122 to 1.128 variance).
Should I push it out to 1.135 or even a little longer 1.140?
Suggestions are much appreciated.
Thanks,