ZBill
Member
- Joined
- Sep 12, 2004
- Messages
- 397
I began to disassemble my Marlin 333 to clean the bolt per my instruction sheet but apparently I did not open the lever far enough (it said open halfway and I only opened it a couple of inches) before taking out the lever screw. Now I can't pull the lever down and out completely (the next step) nor close it as it was before I started. I'm stuck and need help.
What can I do to remedy my problem? Any suggestions are appreciated. Thank you, Bill
What can I do to remedy my problem? Any suggestions are appreciated. Thank you, Bill