So, yesterday I purchased a new Marlin Model 60. When I got it home I noticed that the magaine rod was stuck, so after about 10 minutes of struggling with it, I finally pulled it out. I cleaned it and sprayed some Remoil on it and went to insert it back into the tube. But to my surprise, it would not go further than 3 inches in before getting stuck. :banghead:
I tried to call Marlin, but their customer service doesn't take calls until tomorrow. Any advice? Is this a common problem?
I'm just trying to avoid having to send a brand new gun in for repair right away. Thanks!
I tried to call Marlin, but their customer service doesn't take calls until tomorrow. Any advice? Is this a common problem?
I'm just trying to avoid having to send a brand new gun in for repair right away. Thanks!