par0thead151
Member
- Joined
- Feb 20, 2008
- Messages
- 78
I like to trim my brass on the shorter side of the recommended range as my trimmer is inconsistent with different brands of brass. im not sure if it is the reloading press or the trimmer, but some cases are at 1.759 or above when others are 1.750-1740.
the trimmer is a giraud, so it is quality, not some cheap junker.
should i be concerned about the 1.740 length ones? i dont mind the longer ones as i measure each case before loading, so those get re trimmed to proper length anyways. its the shorter ones that worry me. i usually keep a consistency of 1.748-1.752 when i am set up, however there are a few that are outliers and are above or below that.
the trimmer is a giraud, so it is quality, not some cheap junker.
should i be concerned about the 1.740 length ones? i dont mind the longer ones as i measure each case before loading, so those get re trimmed to proper length anyways. its the shorter ones that worry me. i usually keep a consistency of 1.748-1.752 when i am set up, however there are a few that are outliers and are above or below that.