Revolver Ocelot
Member
- Joined
- Dec 4, 2006
- Messages
- 1,470
A winchester model 70 (pre 64) featherweight has recently come into my possession. When I received it it was in a state of disrepair, most of which was rust on the bolt. I finally have cleaned it up enough where it works, but the 3 position safety is stuck in the fir position.
With some muscling I was able to remove said firing pin and I can see the plunger detent moving when I try moving the safety but it just can never quite make it into the middle position or farther.
Any thoughts?
With some muscling I was able to remove said firing pin and I can see the plunger detent moving when I try moving the safety but it just can never quite make it into the middle position or farther.
Any thoughts?