Tallbald
Member
Placed a Mossberg 590a1 on layaway at gunshop out of town (to keep it from getting away until I can pick it up). I want to exchange the factory stock and fore end for the Hogue 12 Length of pull overmolded stock and fore end. Trouble is, I see conflicting fit information. Some retailers list the Hogue as fitting the Mossberg 500, but don't list the 590A1 specifically.
1)Please someone advise me if they are the same (500 vs. 590A1) for aftermarket stock fitting.
2) The Hogue overmolded fore end may require a longer adapter nut (part number 05020) if the fore end tube on the 590a1 is 6.5 to 6.75 inches in length.
3) To further complicate my purchase, if the action bar is a one piece type, it will need to be replaced with "a standard Mossberg action bar". Huh???
Anyone care to tell me what I will need, or am I best off to wait until it's in my hot little hands and I can figure it out for myself? I was hoping to order it and get it close to the time I pick up my gun. Thanks all, in any case.
Don
1)Please someone advise me if they are the same (500 vs. 590A1) for aftermarket stock fitting.
2) The Hogue overmolded fore end may require a longer adapter nut (part number 05020) if the fore end tube on the 590a1 is 6.5 to 6.75 inches in length.
3) To further complicate my purchase, if the action bar is a one piece type, it will need to be replaced with "a standard Mossberg action bar". Huh???
Anyone care to tell me what I will need, or am I best off to wait until it's in my hot little hands and I can figure it out for myself? I was hoping to order it and get it close to the time I pick up my gun. Thanks all, in any case.
Don