dsv424
Member
I have noticed what may be a problem with my press. When I lower the arm to charge the case I noticed that the hopper does not appear to move fully over the drop hole. When I take the hopper off the powder measure and just place a disc on the powder measure I noticed when I lower the arm that the hole of the disc is only a little more than half way over the drop hole. Is this normal? If not I can't see any way to adjust it align the holes. Can someone who has one of these presses check to see if yours moves completely over the drop hole. I have noticed when I finish loading and remove the hopper and disc that there is a small pile of powder on the powder measure where the disc was.