MoreIsLess
Member
I just got a brand new RCBS lockout die to use on my XL650. Per the instructions, I performed the following steps:
What am I doing wrong?
- Lower the operating arm, raising the platform.
- In the 3rd station, screw the lock out die down until the bottom of the die is about 1/4" from the shell plate (note: I have already attached the plastic white tip to the bottom of the die shaft)
- Raise the arm, lowering the platform and place a correctly charged case in the 3rd station.
- Lower the arm, raising the platform with the charged case, note if the white ring on the die shaft is even with the top of the die.
- If so, the die is adjusted correctly.
- If not, hold the die shaft at the bottom and twist the top of the die shaft and retry steps 4 thru 6 until the die is adjusted correctly.
What am I doing wrong?