Ohen Cepel
Member
Folks,
I'm wanting to switch out the ejector rod on my NM Blackhawk for one with a larger head on it.
Also, want to switch out the housing since the Al is scratched up with a steel housing.
And, while I'm at it going to replace the base pin.
I'm thinking about a locking Belt Mountain base pin (the #5 Elmer's are out of stock at Brownell's). However, not sure which ejector and housing to go with.
Also, any other simple work to improve the revolver would be great. If I like this I might do the same to the old model Ruger I have. Hesitant to mess with it much though.
Thinking about the free spin pawl, but not sure I want to get into that. How rough it it to fit and install?
Input? Opinions? Experience, all appreacitated!
Thanks in advance!
I'm wanting to switch out the ejector rod on my NM Blackhawk for one with a larger head on it.
Also, want to switch out the housing since the Al is scratched up with a steel housing.
And, while I'm at it going to replace the base pin.
I'm thinking about a locking Belt Mountain base pin (the #5 Elmer's are out of stock at Brownell's). However, not sure which ejector and housing to go with.
Also, any other simple work to improve the revolver would be great. If I like this I might do the same to the old model Ruger I have. Hesitant to mess with it much though.
Thinking about the free spin pawl, but not sure I want to get into that. How rough it it to fit and install?
Input? Opinions? Experience, all appreacitated!
Thanks in advance!