I need to replace my ejector spring on my S&W 2213 (22LR). Having trouble on removing the extractor pin so i remove the extractor and switch out my ejector spring. Can anyone give me some instructions (photos/illustrations) please? Any assistance would be very much appreciated.
S&w 2213
- Thread starter ajdomsac
- Start date
- Status
The ejector is located at the left upper rear of the frame and is part of the slide stop assembly on the 422/622/2213/2214 pistol series.
The extractor is located on the right side of the slide assemby.
You do not need to remove the extractor to replace the ejector spring which is also the slide stop spring.
The ejector spring can be accessed by clear & field stripping gun, then removing the left grip panel.
First complex bend spring you see, just above and to rear of trigger is the Slide Stop/Ejector spring.
Take a picture so you know how to orient the new spring in place correctly, then use needlenose to pop the old spring, or the pieces if it is broken, off the frame. HTH
The extractor is located on the right side of the slide assemby.
You do not need to remove the extractor to replace the ejector spring which is also the slide stop spring.
The ejector spring can be accessed by clear & field stripping gun, then removing the left grip panel.
First complex bend spring you see, just above and to rear of trigger is the Slide Stop/Ejector spring.
Take a picture so you know how to orient the new spring in place correctly, then use needlenose to pop the old spring, or the pieces if it is broken, off the frame. HTH
- Status
