I purchased a well worn , mechanically fine model 15-3. It was a purposeful acquisition - I wanted a revolver to serve as a learning platform - disassembly , cleaning , reassembly and so on. So far , so good. Upon disassembly I noticed that the flat head side plate screw was located on the area not covered by the original grips , and one of the oval head screws was beneath the grip. (It left an imprint on the underside of the wood grip.) So I knew that the screws were not in the proper locations. My question : of the two oval head side plate screws , which goes to which location? The base of each looks quite similar , but the head of one is thicker than the other. One retains the crane , the other goes to the location above the aft end of the trigger guard.
Clarification to this trivial question would be appreciated. I am trying to get it right.
'Ski
Clarification to this trivial question would be appreciated. I am trying to get it right.
'Ski