SA XDM 9mm WOLFE MAGAZINE ISSUE

[Hburner2]

I purchased 3 Wolf replacement mag springs for my Springfield Armory XDM 19 rounders and they don’t have the raised part in the middle to catch on hole in polymer floor plate. So the floor plate will move forward, not good. Has anyone else overcome this issue?

 

[BBBBill]

Did you see the note on the web page? -

Magazine Springs​

FOR USE IN:
SPRINGFIELD XDM 9mm - 19 Rounds

Note:
Spring not for use in early 19 round magazines where the spring has a "V" tab on the bottom coil to lock the floor plate on.

 

[Hburner2]

Sure did but had no clue at what point was that being valid to which mags, I assumed mine was new enough but that is what I get for assuming I reckon, tks

 

[Hburner2]

I’m going to attempt a modification to it, but in the meantime I can’t seem to locate a reputable place that sells the correct ones?

 

[Hburner2]

Well I managed to make the semi V shape
And it doesn’t look half bad!!! Base plate locks in tight, so I’m good to go!!!!