ProCharger
Member
Bore sighting my rifle it seemed I had to use shims to get it on target. I had an error on my oart and didnt realize that when you bore sight everything is backwards......I was adjusting to the point where I was trying to move the crosshairs onto the POI when in fact i needed to move the POI to the crosshairs if that makes sense to ya. Well I realized I was going backwards and left the shims under the rear scope ring. At the range my groups were all over the place at 100 yards then I got out an alan wrench and tightened all the mounts a little. Would the shims be enough to cause the scope to move after firing a few times? The shims I used came in the scope ring box. Think I should dismount the scope and remove the shims since I probably do not need them? After tightening everything down I was getting 2MOA with 5 shots using a front rest only. Thanks in advance.
Brett
Brett