Stuck shell remover information needed

[rc109a]

What size tap and drill bit is recommended for making my own broken shell remover? I broke the rim off a 223 shell and now it is stuck in my rcbs small base die. I know that I need to drill then tap the hole. Then using washers and a bolt I can make my own stuck shell remover. Any help would be nice. Thanks...

 

[Shoney]

13/64" drill bit to drill out flash hole

1/4" Tap to tap the inside of the flash hole

1/2" Socket (1/4" drive) goes up against die and allows stuck case to be pulled into it

1/4" x 1 1/2" Washer on top of socket (keeps bolt from gouging the top of the socket)

1/4" x 1" Machine bolt goes into threaded flash hole and is turned to pull case out
If you need extra insurance, get the setup ready, leave the die in the feezer over night, then pull.

 

[rc109a]

Thanks for the help. I am running out to Lowes to get the parts in a few minutes. I have 200 rounds to load by tomorrow so it is vital to get doen soon. Thanks...

 

[rc109a]

Got it out, thanks!

 

[Shoney]

You're welcome! Hope it's your last, but if you are human, like the rest of us, you will need to use that kit again.

Good Shooting!

 

[FlyinBryan]

leave the die in the feezer over night, then pull

why the freezer part?

does it shrink the brass some? or maybe harden the newly tapped threads to avoid stripping them?

just curious.

 

[Shoney]

It actually shrinks both die and brass, but shrinks the brass more than the steel/carbide. The amount of shrinkage is minimal, but enough to tell the difference.