So a issue I have experienced primarily being a bullet caster and like wise cast bullet loader
Is when I bell the case mouth with a M DIE I get a wonderful fit and alignment and the proced to run case into seater die and now I have a shaved lead ring and NY cartridge looks like crap.
I was loading 38 special and this happened so I found a çh 45 acp seating die body and switch the seating stem for 38 shoulder seater style and proceed to seat bullets with NO SHAVINGS.
I can only figure the 38 special seating die is removing my bell and causing this.
Would a die with say an internal ID of .562 with lee style button stems cut to fit the bullet being used be a good idea and fix all of LEE stupid 0 ring nuts and non lockable seating rod threads?
Is when I bell the case mouth with a M DIE I get a wonderful fit and alignment and the proced to run case into seater die and now I have a shaved lead ring and NY cartridge looks like crap.
I was loading 38 special and this happened so I found a çh 45 acp seating die body and switch the seating stem for 38 shoulder seater style and proceed to seat bullets with NO SHAVINGS.
I can only figure the 38 special seating die is removing my bell and causing this.
Would a die with say an internal ID of .562 with lee style button stems cut to fit the bullet being used be a good idea and fix all of LEE stupid 0 ring nuts and non lockable seating rod threads?