Jimfern
Member
I added a pocket clip to a Swiss Army Knife I recently picked up. I popped the non-logo scale off the knife, aligned the used pocket clip I had, so the holes wouldn't interfere with the press fit section and drilled away. Then I forcefully drove the 3 screws in slowly, so I didn't drive the screws too far and strip the plastic threads I made. Putting the scale back on flush required me to stand on the knife, but I don't think that was related the the clip or screws I installed, just the tightness of the press fit. Without standing on the knife, I could see a gap between the scale and the knife.