Keeperfaith
Member
- Joined
- Dec 30, 2010
- Messages
- 235
My buddy has a shotgun that was given to him. The barrel had been cut down to "18" inches and the cut is uneven. I'm afraid his barrel is too short. I was thinking that we can buy a shotgun muzzle brake and have it welded on permanently to avoid any questions to the length of the barrel.
Can anyone give me an idea if this is a difficult/expensive project?
Should I stick w/ a gunsmith or can any welder do the project?
I'm not concerned about the finish of the barrel or muzzle brake as I plan on cerakoting the gun for him.
Thanks
Can anyone give me an idea if this is a difficult/expensive project?
Should I stick w/ a gunsmith or can any welder do the project?
I'm not concerned about the finish of the barrel or muzzle brake as I plan on cerakoting the gun for him.
Thanks