Texas10MM, it won't work UNLESS you run a bullet seater/CRIMP die in 1 die. That is the ONLY way it can work. Because you have to put it in the next station, not the station it is intended....It cannot work, without a shadow of a doubt using powder check and a 4 die system as intended... because obviously, the powder bar SLAMS RIGHT SQUARE INTO IT. Check it out, this is a fact. How can you load when the powder bar wont even open? And Dillon says it wont work? Why would they say that? But don't worrk...Dillon will sell it to you anyway...then when you ask them about it not working, they will say it wont work. Great company.
Dillon ADMITS it won't work, do they have a clue? E-mail dillon...they will tell you exactly as I have said. This is basic to understand. Why don't you do better? Why don't you e-mail the management or owner of Mr. Bullet Feeder, they will tell you IT DOESNT WORK and they are working on a part to fix this issue?
Why dont you look on Dillons web site now? THis is quote from Dillon:
"We here at Dillon understand the issue concerning the simultaneous use of the bullet feeder and the powder check die. We are working to provide a simple fix that will eliminate this problem.”
Why would they be working ON A FIX, when you say the problem is me and I don't have a clue? Could it be, what I said is accurate, totally?
And no, you saw 0 videos with a Mr. Bullet feeder, running a standard 4 die setup, like on a XL650, because it doesn't exist. It cannot work.
Oh, whoops...Mr. Bullet feeder has a page DEDICATED to what I am saying...
https://www.doublealpha.biz/us/mr-bulletfeeder
The current design of the new XL750 does not allow the bullet dropper to be positioned in station #4 of the toolhead because of the angle at which the powder Dispenser bar extends directly towards it. This means the bullet dropper MUST be positioned immediately after the powder dropper, in station #3. That makes it impossible to use a Powder-Check AND a bullet dropper at the same time.
We will attempt to come up with a solution to allow the powder dropper to be rotated to another angle to resolve this issue, but at the moment, be aware of this issue.
Texas10MM, please see the line where it says POWDER CHECK AND BULLET DROPPER IS "IMPOSSIBLE" to use at same time...
??? Have any more questions, I am here for you.