WestKentucky
Member
Went through the motions of loading 223 enough times to be satisfied that my temporary layout could get bolted in as a permanent layout. Then I bought the lag bolts and got them secured. I may swap the rear bolts on my Lee presses for through-bolts with washers because I felt one slip a bit as I snugged up the lag bolt. The fronts are 1/4x4 lag bolts in a 4x4 run tight. The rears are just in a double “screwed and glued” 3/4 plywood. Either way, they aren’t budging right now and getting tooling cleaned up on the PW duomatic again is a bigger concern. I would buy 16ga and .410 if it weren’t so expensive to buy tool change kits.