Search results for query: *

What is the quantitative difference between a standard factory load &, a match load , also factory

It's a 4x20x56 without the silver eagle . Price $237:00 made in China Don't get took.

Do any of our members or guest have any idea about what could be used as packing on top of powder , between bullet & powder , to make every case full & almost compressed even though the inside volume is different. Hoping this would give an even pressure build & more consistent velocity , just...

I'm sure it's been studied by one or more of the experienced loaders we have on here , so please enlighten me as to where to find it , or help me understand it. I don't know how to adjust the powder load for two different volume cases to get the same poi . Could you find a great load with...

Anyone have any opinions either way with experience to back it up . I'm interested

Don't know if I got the cetme part exactly right , but it has the third position on the safety wood stock . Looks kinda like an AK to me , rear peep front post , he wants $500.00 for it. Looks to be in good shape , but I haven't shot it. The lever does not rotate to third position . Is it worth that

I loaded a ladder test for a 7mm REM mag for a tikka t3 rifle once I shot the whole test ( I didn't experience any signs of over pressure ) , I measured the brass 1/8" below the mag ring for lack of the proper name . It was .007" bigger than when new . All of the brass was bigger , I put this...

At what point is a bottleneck case at 100%, at the base of the neck ,or the base of the shoulder ,or some other point. Thanks shooters I know you know

Why do I never see RP brass mentioned on reloading threads

Has any of the bullet mfgs ever made a projectile that was heaviest in the front half but still sleek. I know that when I used to shoot competition archery , we would build our arrows with weight forward & it flew much straighter , less fishtail ,or use . Don't have an engine to make my own , so...

There is a recall on armalite eagle rifles as stated in an alert in American rifleman magazinecan 2017 It says they can fire multiple times because of an out of house part ,that they will replace. JB

Anyone have enough load workup data both good & bad that can use twist rate + velocity to figure rpm of bullets , to see if any correlation with accuracy

Anyone know anything about this scope or company. FFPscope with zero reset ,zero stop , side focus

A friend has one of these in 7x56 with broke stock looking for ammo or steps for making brass for loading . Prefer non corrosive if it exists. Will post pics tomorrow.

Wisconsin,s reciprocity does it include AL yet . I have to go in June & hate to leave all protection to Leo,s that don't know me.

Bought yesterday cleaned last night sighted , or shot this morning . dead on at 25 yards no time to back up & sight at 50 yards. Really nice trigger , pretty much just cuts holes at 25 . Not a lot of felt recoil its stainless & I like it a lot for a 1911. Makes my Block 27 40 feel like a mule...

Nice un

Factory umc 50 gr HP. Took me a few trips back & forth to f. .ind the actual drop at 500 ,my calc was off 12" " did not come to shoot but to turkey hunt & fish. So all I had with me was a 12" x12" target & a vote for me sign with thick woods for backdrop.. Any way after getting on sign I dialed...

Is supeformance ammo for bolt guns only. Had the first Three rounds out of a new box blow primers all the way out, while leaving the case in the chamber .removed next bullet in line ,closed bolt & case ejected without a lot of force exerted

I know that if you have a 1" ram on a hydraulic cylinder with 1000 psi the ram will move at a given speed with a 500 lb load . If you truncate the fluid end of the ram giving to a 2" surface area then the ram will lift the same load at twice the speed producing 2000 lb of lift . Now my question...