40s&w

I am in the midst of processing a 1000-lot of 1xF 40S&W cases. (First time loading 40S&W) After I sorted for head stamps I had a bunch of R-P cases, and some (17 out of 224) had glock-bulge. Ran them all through my new G-Rx die. The guppy belly is gone, but there is still a 'frown' (groove)...

what is a load for 40S&W using 160gr RN bullets? I have 231 powder but I can only find info for 155gr and 165gr bullets. should I load to weights between the two?

I ended up on "Thefiringline" Blog and read many different opinions about Trailboss, Some said Lead Only, Some said No Crimps, others the exact opposite. Others said Trailboss will work in any case as long as it is not compressed by the bullet. Some said crimps were required to reach...

As most probably know, P226 in 9mm uses the #8 front sight while in 40S&W - #6 front sight, which is 0.28mm taller than #8, while the rear sights are the same (#8) - see: https://www.realgunreviews.com/sig-sauer-sight-heights-sight-numbers/ The question is why then Glock 17 and 22 use exactly...

I don't have any experience with 10mm, but I was reading where a fellow said he could shoot 40 S&W out of a 10mm gun. I know the 40 is a cut down 10mm but I didn't think you could shoot 40 out of a 10mm. Unless he is doing something stupid.

Hey everyone, I'm wondering if I'm the only one around who would be interested in a nice, modern 9mm or 40 S&W bolt action. With 22lr so hard to find, I think a bolt gun (especially in 9) would be cheap to feed (as a reloader) and would provide a little more utility than a rimfire. Also, I...