MI2600
Member
I converted some .223 brass to 7.62X25. When I loaded the bullets in two cases they would not chamber in my M57. There appeared to be a bulge in the neck.
After browsing here, one thread mentioned running the loaded rounds back through the sizing die, without the decapping pin. I tried it and the rounds chambered perfectly.
Should I be concerned about the bullets being too tight in the brass?
After browsing here, one thread mentioned running the loaded rounds back through the sizing die, without the decapping pin. I tried it and the rounds chambered perfectly.
Should I be concerned about the bullets being too tight in the brass?