bobotech
Member
I am thinking about getting a Hornady Lock and Load single stageto replace my old small RCBS press so that I could use the dies that I setup to use with my Lock and Load AP.
My question is this, does the L'nL single stage have the same throw so that if I set a die to crimp on my AP press, will it not need adjusting on the single stage Lock and Load?
I would be using the typical Lee shell holders.
My question is this, does the L'nL single stage have the same throw so that if I set a die to crimp on my AP press, will it not need adjusting on the single stage Lock and Load?
I would be using the typical Lee shell holders.