I was gifted a new pistol for Father's Day and I spent a little time at the range with it, thought I would post some comments.
When I was looking at it right out of the box I noticed sparkles in the case, looked at it and there is NO lube on this gun at all, my other EAAs (Witness) were dripping grease. I usually put a few downrange before I clean and oil my guns but did this on ebefoe going. Comes apart like any CZ clone and shares mags with my CZ75. Has tight tolorences, no rattles or slop in it. Much lighter than the Witness or CZ ( my first polymer one)
At the range:
I used S&B and Federal 115 fmjs, 100 rounds total. Factory mag and a witness 40 mag with the feed lips sqeezed in (this mag feeds horribly on purpose). No fail to fire, no extraction failures and no double feeds, which my mag is always been good for. POI and POA seem off by a bit the first 30 rounds all hit low and I had hell trying to compensate but it points instictively and I was more accurate drawing and point shooting that slowly aiming each shot.
Shooting 2 handed it felt a lot like my Witness .40, a bit of snap but easily controlled, one handed it took a little time to get back on target, and off handed...honestly I almost droppednit the first offhand round. Did I mention its my first polymer? I have shot polymers before but I guess I never tried off hand and I was not prepared for that much muzzle flip. The gun is accurate though, every miss made a tight group under the target
and as a reloader I definately appreciate the 5' circle off my 4 o'clock it dumped all my brass in.
In all it seems a good additon to my CZ/clone collection and if it proves reliable may see some carry duty as its soooo much lighter than even my Compact. It does not however fit in my CZs Fobus which kinda sucks but it should fit in the same as my Witnesses with just a little slop until I can find on ejust for it.
I'll try to update this as I get more triggr time with it
When I was looking at it right out of the box I noticed sparkles in the case, looked at it and there is NO lube on this gun at all, my other EAAs (Witness) were dripping grease. I usually put a few downrange before I clean and oil my guns but did this on ebefoe going. Comes apart like any CZ clone and shares mags with my CZ75. Has tight tolorences, no rattles or slop in it. Much lighter than the Witness or CZ ( my first polymer one)
At the range:
I used S&B and Federal 115 fmjs, 100 rounds total. Factory mag and a witness 40 mag with the feed lips sqeezed in (this mag feeds horribly on purpose). No fail to fire, no extraction failures and no double feeds, which my mag is always been good for. POI and POA seem off by a bit the first 30 rounds all hit low and I had hell trying to compensate but it points instictively and I was more accurate drawing and point shooting that slowly aiming each shot.
Shooting 2 handed it felt a lot like my Witness .40, a bit of snap but easily controlled, one handed it took a little time to get back on target, and off handed...honestly I almost droppednit the first offhand round. Did I mention its my first polymer? I have shot polymers before but I guess I never tried off hand and I was not prepared for that much muzzle flip. The gun is accurate though, every miss made a tight group under the target
and as a reloader I definately appreciate the 5' circle off my 4 o'clock it dumped all my brass in. In all it seems a good additon to my CZ/clone collection and if it proves reliable may see some carry duty as its soooo much lighter than even my Compact. It does not however fit in my CZs Fobus which kinda sucks but it should fit in the same as my Witnesses with just a little slop until I can find on ejust for it.
I'll try to update this as I get more triggr time with it
