I am having a problem where my slide is not fully closing everytime after a round is fired. It is a brand new gun with probably 1000-1200 rounds through it, cleaned every 150-400, 150 at first and now at the end of the week which usually involves about 400 rounds.
What happens is that I will chamber a round, pull the trigger, it goes bang and then it automatically chambers another round, and sometimes it goes click or I won't be able to pull the trigger. If it goes click I usually recock with thumb and then push the slide forward from the rear, it usually moves a mm or 2 and then I pull the trigger and the gun will go bang. If I can't pull it then I usually have to push the slide a bit further than the up to 2mm, regrip, and then gun will go bang.
When it has gone click, I have ejected the bullet at times and consistantly it does not have a strike on the primer.
It really started doing this in the past 400 rounds.
What do you think?
What happens is that I will chamber a round, pull the trigger, it goes bang and then it automatically chambers another round, and sometimes it goes click or I won't be able to pull the trigger. If it goes click I usually recock with thumb and then push the slide forward from the rear, it usually moves a mm or 2 and then I pull the trigger and the gun will go bang. If I can't pull it then I usually have to push the slide a bit further than the up to 2mm, regrip, and then gun will go bang.
When it has gone click, I have ejected the bullet at times and consistantly it does not have a strike on the primer.
It really started doing this in the past 400 rounds.
What do you think?