ohihunter2014; said:just opened my lee auto drum and put it on the press empty and it wont rotate or move the metal rod at all.
btw read directions and no help. it moves by hand but not in the charge die and really hard by hand.
thank you sir.The small drum goes up to at least 25 gr. of H335 and 27 gr. of CFE223.
ill try that. I noticed something about that in the directions too.You're welcome.
Someone posted a while back an easy set up tip. Weigh out the desired amount of powder on your scale. With the drum out of the unit, back out the threads of the drum to create enough cavity. Pour the weighed amount of powder into the drum. Then screw the threads back in until the powder is flush with the brim of the drum. That will get it close enough to tweak in.
Someone posted a while back an easy set up tip. Weigh out the desired amount of powder on your scale. With the drum out of the unit, back out the threads of the drum to create enough cavity. Pour the weighed amount of powder into the drum. Then screw the threads back in until the powder is flush with the brim of the drum. That will get it close enough to tweak in.
Not coming off cocky but what is there to take apart other than the drum and hopper? The other parts with the spring and such don't appear to be user friendly when it comes to that.If you think you didn't get some oil/lube/preservative out, don't spray stuff in to clean it.
Take the whole thing apart and clean it properly
Inside the hole the drum goes and on gears. Seen it on a few other places so tried it.