problem with square deal handle !!!!!

[alca]

I have a problem, i don't know if someone could help me to resolve.
I cleaned my square deal, under shelplate etc, put a little prolix (lubricant) on the wave bearing white parts and since this time, my handle is very, very hard to stroke...........
Why???

Thank you

 

[Certaindeaf]

Not sure but if that is nylon, generally, it is self lubricating..

 

[loadedround]

When all else fails, call Dillon!

 

[MtnCreek]

I don't have a SD, but their other presses will get real tight if you overtighten the shell plate or forget to tighten the set screw. Might want to re-check them.

 

[hang fire]

You are right. I tighten until resistance to rotation, then back off a mite.

 

[MtnCreek]

You are right.

It was bound to happen sooner or later.

 

[Seedtick]

I clean and lube the wave bearings on my SDB and I've never had any trouble.

The times I've needed to contact Dillion I've always just sent them a message through their 'Contact Us' page. They usually respond in 24 hours or less by email. They will know what's going on.

HTH

Seedtick

 

[alca]

Hello, just to mention that I found the problem and I want to share in case someone would have the same problem. There is a small screw at the base of the handle, you must remove the assembly for prmers to view, and well just put a little oil and it slides all alone now.

Thank you all for your help, very appeciate

 

[jmorris]

FWIW the SD's shell plate bolt is designed so you tighen it down on the shoulder. Unlike the 650 where you back off and lock it inplace with a set screw fromm the side.