codefour
Member
I do not know if I should post this in Rifle Country or the Reloading forum but here goes....
I recently bought a Saiga in .223 and ordered the parts to convert it to an AK configuration. I recently shot my NIB Saiga at my local club.
I reload all my own cartridges. I can reload competition level .223 for a little over half the cost of new, bulk, cheap ammo. Every case I retrieved had a LARGE ding in the side of the case. I full lenth resized the cases and the ding would not come out.
Is there a modification to the Saiga rifle to prevent the LARGE ding in the side of the cases.?? The case seems to strike the receiver cover after it is ejected. Does anyone know of a mod to the receiver cover that can prevent this ding.??
Any help would be greatly appreciated. I feel like I am waisting good brass...
I recently bought a Saiga in .223 and ordered the parts to convert it to an AK configuration. I recently shot my NIB Saiga at my local club.
I reload all my own cartridges. I can reload competition level .223 for a little over half the cost of new, bulk, cheap ammo. Every case I retrieved had a LARGE ding in the side of the case. I full lenth resized the cases and the ding would not come out.
Is there a modification to the Saiga rifle to prevent the LARGE ding in the side of the cases.?? The case seems to strike the receiver cover after it is ejected. Does anyone know of a mod to the receiver cover that can prevent this ding.??
Any help would be greatly appreciated. I feel like I am waisting good brass...