Please also note that some of your magazines may need a different base plate or may not work with the longer grip.
It's drop in replacement. I can swap grip modules in less than 30 seconds. Just remember to push out the receiver retaining pin from the right to the left, and re-insert the pin from the left and push towards the right. The reason for this is that the retainer spring for the receiver pin is mounted on the right side. You only need to push the pin about 1/8' to the left before it comes free of the retainer spring.
So I really would not have to do anything except take the slide and barrel off my 365 XL and put on the 365 slide and barrel, right?
You can take the P365XL slide assembly off of your XL and put any other P365 slide assembly back on with no fitting, no additional parts, and no other modifications. Most of the replies in this thread cover swapping the polymer grip module, which involves removing the retaining pin before pulling out the FCU - but if I read your post right you were just asking about swapping out slides to turn an XL into an X. Hope this helps.So I really would not have to do anything except take the slide and barrel off my 365 XL and put on the 365 slide and barrel, right?
You can take the P365XL slide assembly off of your XL and put any other P365 slide assembly back on with no fitting, no additional parts, and no other modifications. Most of the replies in this thread cover swapping the polymer grip module, which involves removing the retaining pin before pulling out the FCU - but if I read your post right you were just asking about swapping out slides to turn an XL into an X. Hope this helps.
Yes, I am just trying to turn an XL to an X. I want a 365 length slide and barrel on my 365 XL frame. I think all I would have to do is change the slide, barrel, and recoil spring.
Yes, I am just trying to turn an XL to an X. I want a 365 length slide and barrel on my 365 XL frame. I think all I would have to do is change the slide, barrel, and recoil spring.