scythefwd
Member
ok, I got to take a sawzall to a liberty "safe" today. It is the smallest centurion they make. I was just idening the hinge cutouts a hair to assist in putting the door back on... Don't ask.
anyways, my hitachi 13 amp sawzall went through it like butter. I'm pretty sure I could cut it in half in less than the four minutes needed to pry it open.
to the experts on the board, is there a real safe out there that could withstand this approach for more than 10 - 15 minutes? It'd have to have some steel quite a bit thicker than 1/8 inch... Probably 1/4 would slow me down a bit, but I stll think I could get a hole in a safe that thck large enough to empty it in 15-20 min.
anyways, my hitachi 13 amp sawzall went through it like butter. I'm pretty sure I could cut it in half in less than the four minutes needed to pry it open.
to the experts on the board, is there a real safe out there that could withstand this approach for more than 10 - 15 minutes? It'd have to have some steel quite a bit thicker than 1/8 inch... Probably 1/4 would slow me down a bit, but I stll think I could get a hole in a safe that thck large enough to empty it in 15-20 min.