Cowboybebop
Member
So I got the new MRO Patrol with the QD mount. Being QD it stands to reason that you should be able to hand-tighten the bolt with just fingers, however when tightening as hard as I can the mount starts to loosen after 3 rounds out of a 5.56 rifle.
There is no torque spec in the manual for this bolt. There is a hex head for a wrench, so I can tighten it more, but then isn't the QD aspect gone as it is too tight to remove in the field?
If I did tighten it with a wrench, what would you guys recommend for inch-pounds?
Thanks
There is no torque spec in the manual for this bolt. There is a hex head for a wrench, so I can tighten it more, but then isn't the QD aspect gone as it is too tight to remove in the field?
If I did tighten it with a wrench, what would you guys recommend for inch-pounds?
Thanks