Mind telling us why? I'd rather not read that entire thread.
The stainless is hard to find. You can find the Cerakote model on www.gun.deals.So where we at now after a couple months? Anyone else picked one of these up?
I have to admit I have a bit of a craving for a stainless model. Or are they all stainless but one is painted and the other is not?
Mind telling us why? I'd rather not read that entire thread.
3 Extractors have broken and the importer says they have redesigned it. A firing pin retaining plate cracked. There is a claim that the barrels might be defective, off center with bad crowns.
The extractor and firing pin stop issue has been pretty well known. Several videos that have reviewed them have already mentioned it. It's also why Cylinder and Slide just also came out with an aftermarket firing pin stop.
I haven't heard any affirmative evidence about bad barrels, but just personally for the price I don't care if I had to replace the firing pin stop and extractor.
Realistically Browning isn't making the gun any more. I think its still good to have the base platform available even if it does need some aftermarket love to make it run just right (heck very few of my guns end up remaining completely stock anyways - even my FN Hi Power is sporting a C&S extractor).
3 Extractors have broken and the importer says they have redesigned it. A firing pin retaining plate cracked. There is a claim that the barrels might be defective, off center with bad crowns.
Are these new to market or just new to the US market?What would one expect for a clone. Especially one new to the market.
Are these new to market or just new to the US market?
There are some crazy low prices for these at the moment, like 350 on Gun Broker.
If those Turks would put a factory ambi-safety on it, I'd probably but 1 or 2 of them.
The only videos Ive seen on this thing were done by the Yankee Marshall.