I have been loading 357 Mag loads for a while and seem to constantly run out of brass for it...but I have plenty of 38 Special brass. I noticed that some 357 loads have lots of room left for the bullet, so I dumped the load in a 38 Special casing...and had plenty of room left for the bullet also....125 gr JHP...since I fire a Ruger Blackhawk 357 SS only for these rounds, would this be a dangerous load pressurewise for the gun?
I have split open and measured the thickness of the brass of all three casings and found that the +P casing appears as sturdy as the 357 casing....but will the +P casing safely accept the pressure of the 357 load?
I have split open and measured the thickness of the brass of all three casings and found that the +P casing appears as sturdy as the 357 casing....but will the +P casing safely accept the pressure of the 357 load?