whughett
Member
From Winchester Sutler I purchase a Rapine .454215 two cavity mold.
Intended to use these in my 1860 Army and Walker. Turns out they are too long and will not fit under the ram area. They work real well in the ROA so nothing lost.
Would like to try conicals in my other guns, aforementioned and the Navy Arms Remington 1868 in .36 cal. ( This gun works best with a .380)
I don't like to buy bullets as just a few hundred of self cast offsets the cost of a mold.
What conical molds are shooters on this forum using for 44 cal or 36 cal bullets. I assume the mold would have to throw a conicial weighing less than 215 grains,( for 44's).
Intended to use these in my 1860 Army and Walker. Turns out they are too long and will not fit under the ram area. They work real well in the ROA so nothing lost.
Would like to try conicals in my other guns, aforementioned and the Navy Arms Remington 1868 in .36 cal. ( This gun works best with a .380)
I don't like to buy bullets as just a few hundred of self cast offsets the cost of a mold.
What conical molds are shooters on this forum using for 44 cal or 36 cal bullets. I assume the mold would have to throw a conicial weighing less than 215 grains,( for 44's).