Kimber II and Wilson Ejector

[fedlaw]

The rear of the stock ejector on my Kimber Stainless Target II has loosened up a bit. (The ejector does not wiggle side to side; the rear of the ejector goes slightly up and down, and the gun is still 100% reliable.) I called Kimber and the service tech told me not to worry as the slide will keep it in place, but that if I wanted to, I could sent it in and they would fix it under warranty.
I was thinking that instead of sending the gun back to Kimber, I would replace the ejector with a Wilson Extended Ejector. Have any of you folks done that with the Series II with the external extractor? If so, how has it worked out?
Thanks,
Steve

 

[CDignition]

Dont worry it, it wont hurt anything, and the extended ejector will likley need tuning/adjusting...I would leave it

 

[fedlaw]

Dont worry it, it wont hurt anything, and the extended ejector will likley need tuning/adjusting...I would leave it

Thanks CDignition, sage advice. When I put a strong light on the ejector and used more powerful glasses, I saw that the ejector has a small pin through the ejector and its front leg. My assumption is that this acts as a pivot point. IOW, Kimber must have made this change to the traditional ejector. Has anyone else noticed this?
Steve