My Lee die has the deprimer pin retracting into the die when using. I figured out how to unscrew the deprimer and get the pin to stick out where it should. I continued deprimer/resizer and the pin moved a bit.
So instead of messing around with it, I used my universal decapper to process the 500 pieces of brass.
So after it finished, I put back the decapper/sizer and started resizing. At this point, it wasn't the primers that was pushing the pin into the die, it was just the action of the resizing.
Has anyone had this issue, and if so, how did you correct it?
If it makes any difference, I was resizing 9x19 to 9x18 Makarov.
So instead of messing around with it, I used my universal decapper to process the 500 pieces of brass.
So after it finished, I put back the decapper/sizer and started resizing. At this point, it wasn't the primers that was pushing the pin into the die, it was just the action of the resizing.
Has anyone had this issue, and if so, how did you correct it?
If it makes any difference, I was resizing 9x19 to 9x18 Makarov.