bob97
Member
So i am entertaining the thought of building a supressor on a form 1. Form 1 to reduce cost and wait, rather than 1000 bucks for a hybrid 46 and one year.
Purpose of can would be for hunting rifle in 45-70. A somewhat short break action.
I am moderately handy and am friends with a machinist or two. Is there any recommended reading material? I am thinking SS for the balance of machinability and durability. I think i am too clumsy for an aluminum can. I can figure out all the dimensions, fits, etc. just a few basic ideas on what works and what doesn’t - Bang for your buck experience.
Monocore? Welded baffles? Loose baffles? 17-4? 316L? Skip SS and find a 4140 bar? Or not worth the trouble?
Thanks
Purpose of can would be for hunting rifle in 45-70. A somewhat short break action.
I am moderately handy and am friends with a machinist or two. Is there any recommended reading material? I am thinking SS for the balance of machinability and durability. I think i am too clumsy for an aluminum can. I can figure out all the dimensions, fits, etc. just a few basic ideas on what works and what doesn’t - Bang for your buck experience.
Monocore? Welded baffles? Loose baffles? 17-4? 316L? Skip SS and find a 4140 bar? Or not worth the trouble?
Thanks