Bought a 20" .223 Wylde Super Sniper straight fluted, brushed stainless steel AR15 barrel from Wilson Combat.
Put it on, then ran a bore snake through it to clean out any oil/debris... only to have it get STUCK to the point I had to clamp the bore snake in a vice and pull so hard I thought it was going to break. Turns out, the barrel has a significant burr where they drilled the gas port. All those high expectations, time waiting and work for nothing... BACK IT GOES.
You'd think they would drill the gas port BEFORE the rifling was done. That way, the rifling process would smooth out any burrs from drilling the gas port hole. That, AND you'd hope quality control was doing something besides playing on their phones...
Oh well. Bough a new car part that was defective. That came in yesterday and went back today.
It's getting ANNOYING.